Publicité
I_Enjoying the sounds
0
(if you selected SFC in step 5)
by remote control only
Press [SFC] to select the desired SFC
mode.
The mode changes each time you press the button while
the modes are displayed.
7 start the source.
8
Adjust the volume.
While using the SFC modes
by remote control only
To adjust speaker level
® Press [LEVEL] to select the speaker channel to adjust.
Each time you press the button subsequently, the speaker
whose level is to be set is selected in the listed sequence.
C- RS- LS-SW
Speakers for which "NONE" or "NO" has been set are skipped.
(D
Press [+] or [-] to adjust the output level.
Channels C, RS, LS, and SW can be adjusted between -10 dB
and +10 dB.
by remote control only
To adjust delay time
You can adjust surround channel only.
Adjust the delay time of the sound from the surround speakers to '
produce the proper effect.
® Press [DELAY].
When you press the button, the current delay time is displayed.
®
Press [+] or [-] to set the lime.
Select a delay time to suit your individual needs.
Delay time can be set at
lO-milliseconds (ms) inten/als
between 10 and 100 ms.
The factory settings for each mode are 50 ms.
For your reference
Speaker level and delay time can be set for each SFC mode.
When you finish listening
Be sure to reduce the volume and press [POWER, cb/l] to switch
the unit to standby.
For your reference
• If you are using a VCR (connected to VCR 1) and you select
TAPE, CD, TUNER, or PHONO
The picture will remain on the screen.
• About DSP sound mode
The DSP sound modes can be set for each source. Once you
have set the mode for a source, the mode is engaged whenever
that source is selected.
These
modes
are
automatically
switched
to
STEREO
if
SPEAKERS B is selected or both SPEAKERS A and B or BI¬
WIRE are turned off. When SPEAKERS B is turned off or
SPEAKERS A or BI-WIRE is selected, the mode is switched
back to the latest mode.
• Only Dolby Digital, DTS or PCM signals (44.1 kHz or 48 kHz)
can be reproduced through the digital terminal
The digital input signal of sampling frequencies 96 kHz or 192
kHz and other signal formats such as MPEG cannot be
reproduced on this unit.
RQTS512
Publicité
