Publicité
Preparatory steps
BALANCE
SPEAKERS
B
BI-WIRE
^SPEAKERS—\
vP
J
Adjusting speaker output level
Adjust speaker level so the output from all the speakers is the
same apparent level when sitting where you would normally enjoy
a source.
1
Press [A]
or
[BI-WIRE]
to turn on
SPEAKERS.
A or BI-WiRE refer to the speaker terminals at the rear of
the unit.
You cannot adjust output level when SPEAKERS B is
selected.
by remote control only
Press [TEST] to output the test signal.
"TEST" appears on the display.
The signal is output from each speaker in order for about
two seconds each:
L Front speaker (left)
C: Center speaker
R: Front speaker (right)
RS: Surround speaker (right)
LS: Surround speaker (left)
SW: Subwoofer
Speakers set as "NONE" or "NO" are skipped.
DSP sound mode switches to SURROUND mode when the
test starts.
by remote control
Press [VOLUME (+ or -)] (SA-DA10) or
[VOL{-or+)](SA-DA8/DX1040) to set
the volume level normally used for
enjoying the source.
Use [BALANCE] if the left right balance of the front
speakers is off.
5
*
^
D
L- C-R^ RS^ LS^SW
rat SA-DA8/DX1040
o o
SA-DA8/DX1040
/ / _/
U
I 11 I n
C^ RS— LS —SW
SA-DA8/DX1040
oo
J.
ff
/
n ! n
by remote control only
Press [LEVEL] to select the speaker
channel to adjust.
The current level appears on the display.
Press again to change the speaker channel.
Speakers set as "NONE" or "NO" are skipped.
by remote control only
Press [+] or [-] to adjust the level to
the same apparent level as the front
speakers.
The four channels can be adjusted between -10 dB and
+10 dB, with zero being the current level of the front
speakers.
6
Repeat 4 and 5 for each speaker
channel.
To stop the test signal
Press [TEST].
The test signal will not be output if VGCA is ON (# page 27).
RQT5512
Publicité
