Start-Up And Use; Restoring The Factory Settings - Hotpoint Ariston OK1037ELD 0 X/HA Mode D'emploi

Start-up and use

! The first time you use your appliance, heat the empty oven with its door
closed at its maximum temperature for at least half an hour. Make sure that
the room is well ventilated before switching the oven off and opening the
oven door. The appliance may emit a slightly unpleasant odour caused by
protective substances used during the manufacturing process burning away.
! To make the setting process easier, press and hold the " " and " " icons
to scroll through the numbers on the display rapidly.
! Each setting will automatically be stored in the appliance memory after 10
seconds.
! During operation, we recommend the removal of any crockery or delicate
foodstuffs from the cavities not being used.
! Once cooking has begun, before the DIVIDER is removed, the oven must
be switched off using the button.
! Every time the oven is switched on it is set to the CREATION cooking mode.
! The touch controls cannot be activated if the user is wearing gloves.
! In order to optimise the cooking performance, when starting the selected
function, product settings will be applied that could cause a delayed start of
the fan and heating elements.
Control panel lock
! The control panel can be locked while the oven is off, once cooking has
started or finished and during programming.
To lock the oven controls, press and hold the
A buzzer will sound and the TEMPERATURE display shows the key symbol
"O—n". The icon will light up to indicate lock activation.
To deactivate the lock, press and hold the
seconds.
Setting the clock
! The clock can only be set when the oven is switched off. If the oven is
in standby mode, pressing the
setting. Press it again to set the time.
After connection to the power supply network or after a blackout, the
icon and the digits on the TIME display will flash for 10 seconds.
To set the clock:
1. Press icon .
2. Adjust the hour figure using the " " and " " icons.
3. Once you have reached the correct hour value, press the
4. Repeat the above process to set the minutes.
WARNING! The oven is provided
with a stop system to extract the
racks and prevent them from
coming out of the oven (1).
As shown in the drawing, to extract
them completely, simply lift the
racks, holding them on the front
part, and pull (2).
icon for at least 2 seconds.
icon again for at least 2
icon once will display the current time
icon.
If a blackout occurs, it will be necessary to reset the clock. If the
flashes on the display, this indicates that the clock has not been set correctly.
Setting the minute minder
! The minute minder may be set regardless of whether the oven is switched
on or off. It does not switch the oven on or off.
When the set time has elapsed, the minute minder emits a buzzer that will
automatically stop after 30 seconds or when any active button on the control
panel is pressed.
To adjust the minute minder, proceed as follows:
1. Press icon .
2. Set the desired time using icons " " and " ".
3. Once you have reached the desired value, press the
The lit symbol will remind you that the minute minder is on.
To cancel the minute minder, press the
icons to set the time to 00:00. Press the
The icon will switch off to indicate that the minute minder has been
disabled.
Cooling ventilation
In order to cool down the external temperature of the oven, a cooling fan
blows a stream of air between the control panel and the oven door, as well
as towards the bottom of the oven door. At the beginning of the FAST CLEAN
mode, the cooling fan operates at low speed.
! Once cooking has been completed, the cooling fan continues to operate
until the oven has cooled down sufficiently.
Oven light
The light comes on when the oven door is opened or when a cooking mode
starts.
When models featuring LED INSIDE technology begin cooking, the LEDs on
the door light up for improved illumination of all cooking levels.
The icon can be used to switch on the light at any time.
Residual heat indicators
The appliance is fitted with a residual heat indicator. When the oven is off, the
"residual heat" light on the display comes on to indicate high temperatures
inside the oven cavity. The indicator light switches off when the inside of the
oven has cooled down.
Demo mode
The oven can operate in the DEMO mode: all heating elements are
deactivated, and the controls remain operative.
To activate DEMO mode, press and release icon
" " simultaneously for 6 seconds, and then press and release icon
buzzer sounds and the TEMPERATURE display shows "dEon".
To deactivate DEMO mode, when the oven is off press and hold icon
and icon " " simultaneously for 3 seconds. A buzzer sounds and the "dEoF"
message disappears from the display.

Restoring the factory settings

The oven factory settings can be restored to reset all selections made by
the user (clock and customised durations). To carry out a reset, switch off
the oven, then press and hold the button corresponding to the first manual
cooking mode (top left) and the
icon
icon again.
icon and use the " " and " "
icon again.
, then icons " " and
. A
icon simultaneously for 6 seconds.
25
GB