Oven; Start-Up And Use - Hotpoint Ariston FK 1047L P 0 X/HA Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39

Start-up and use

!
closed at its maximum temperature for at least half an hour. Make sure that
the room is well ventilated before switching the oven off and opening the
oven door. The appliance may emit a slightly unpleasant odour caused by
protective substances used during the manufacturing process burning away.
! Turn the control dial to adjust the parameter shown on the display between
! To make the setting process easier, keep the knob in position: this will
increase the scrolling speed of the numbers on the display.
! Each setting will automatically be stored in the appliance memory after 10
seconds.
! The touch controls cannot be activated if the user is wearing gloves.
Some models are equipped with a system of hinges which allows the door to
close slowly, without the user having to follow the movement through with his/
her hand. To use the system correctly, before closing the door:
• Open the door fully.
• Do not force the closing movement manually.
In order to optimise the cooking performance, when starting the selected
function, product settings will be applied that could cause a delayed start of
the fan and heating elements.
on the user should also switch on the control panel by pressing the
button. The list of languages will appear in the menu. To choose the desired
Once the selection has been made, the display will show the settings menu.
Press the
icon or scroll through using the control dial until you reach the
EXIT command and press the
! After choosing the language in the menu, if the display is not used for another
30 seconds it will automatically revert to programming mode.
Setings menu commands
To enter the settings menu, switch on the control panel and press the
Use the control dial to highlight the individual menu commands.
To modify the setting, press the
The following parameters are listed in the menu:
LANGUAGE: select the language shown on the display.
PYROLYTIC: select the cleaning type.
CLOCK: set the exact time.
TONE: activate/deactivate keypad tone.
WARNING! The oven is provided with
a stop system to extract the racks and
prevent them from coming out of the

oven (1).

As shown in the drawing, to extract
them completely, simply lift the racks,
holding them on the front part, and
pull (2).
icon.
icon to begin using the oven.
icon.
icon.
LIGHT: activate/deactivate the internal oven light during cooking.
LOGO: activate/deactivate logo on start-up.
GUIDE: activate/deactivate operating tips.
EXIT: exit the menu.
! It is possible to exit the settings menu by pressing the
Control panel/door lock
! The door and control panel can be locked while the oven is off, once cooking
The door/control panel lock can be used to lock the oven door and/or controls.
To activate it, press the
icon and select the desired command by
pressing the control dial:
• NO LOCK: deactivate an active lock;
• ONLY BUTTONS: only lock the controls;
• ONLY DOOR: only lock the door;
• BUTTONS AND DOOR: lock the controls and the door.
icon.
The lock may be activated while the oven is in use, or while it is switched off.
It can also be deactivated in all the above situations and after the oven has
! When cleaning the appliance, the door lock may be closed accidentally
(there is an exposed spring). If this happens, reopen it by turning the door
lock upwards (
).
KO
OK
Setting the clock
To set the clock, switch on the oven by pressing the
and follow the steps described.
1. Scroll through the menu commands using the control dial, select CLOCK
and press
.
2. Adjust the time using the control dial.
3. Once you have reached the correct hour value, press the
4. Repeat steps 2 and 3 to set the minutes.
5. To exit adjustment mode, press the
through the menu until you reach EXIT, then press
! The clock can also be set while the oven is off, by pressing the
and carrying out steps 2 to 4 as described above.
After the appliance has been connected to the mains, or after a blackout, the
clock will need to be reset.
icon.
icon will appear on the display.
icon, then press
icon.
icon or use the control dial to scroll
.
icon
27
GB

Publicité

Table des Matières
loading

Table des Matières