Replacing The Light Bulb; Troubleshooting; Sliding Rack Kit Assembly - Hotpoint Ariston OK1037ELD 0 X/HA Mode D'emploi

3. Grip the door on the two outer sides and
close it approximately half way. Pull the
door towards you, lifting it out of its slot (see
diagram). To replace the door, reverse this
sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.

Replacing the light bulb

Lamp
Holder
compartment
Lamp
Glass cover
! Do not touch the light bulb directly with your hands.
! Do not use the oven lamp as/for ambient lighting.

Troubleshooting

Problem
The "Clock button" and the digits on the
display flash.
A programmed cooking mode does not
start.
Only the high luminosity "Clock button"
is lit.
An automatic mode has been selected.
"Hot" appears on the display and
cooking does not start.
Fan-assisted cooking has been
selected and the food looks burnt.
F
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: halogen lamp
voltage 230 V, wattage 25 W, cap G 9.
3. Replace the glass cover (see
diagram).
Possible cause
The appliance has just been connected to the
electricity mains or there has been a blackout.
There has been a blackout.
The appliance is in
The temperature inside the oven is higher
than the suggested value for the selected
mode.
Positions 1 and 5: the direct heat could cause
temperature-sensitive foods to burn.

Sliding rack kit assembly

A
Left
Right guide
guide rail
rail
B
C
D
! Do not place the sliding racks in position 5.
Solution
Set the clock.
Reprogram the cooking mode.
standby mode. Press any button to exit standby mode.
Wait for the oven to cool down.
We recommend switching dripping pan
positions halfway through cooking.
To assemble the sliding racks:
1. Remove the two frames, lifting them
away from the spacers A (see figure).
2. Choose which shelf to use with the
sliding rack. Paying attention to the
direction in which the sliding rack is to
be extracted, position joint B and then
joint C on the frame.
3. Secure the two frames with the
guide rails using the holes provided
on the oven walls (see diagram). The
holes for the left frame are situated at
the top, while the holes for the right
frame are at the bottom.
4. Finally, fit the frames on the spacers
A.
33
GB