Publicité
• Before each cleaning and maintenance
• Aer every use
CAUTION! Health hazard
To avoid contamination of food, observe the following instructions:
• Check if the cooling capacity of the cooling device is suitable for storing the food to be cooled.
• Food may only be stored in its original packaging or in suitable containers.
• Opening the cooling device for long periods of time can cause significant increase of the
temperature in the compartments of the device.
• Clean regularly surfaces that can come in contact with food and accessible drainage systems.
If the cooling device is le empty for long periods:
• Switch off the cooling device.
• Defrost the cooling device.
• Clean and dry the cooling device.
• Leave the lid open to prevent mold from developing within the cooling device.
NOTICE! Damage hazard
Check that the voltage specification on the data plate corresponds to that of the energy supply.
Only connect the cooling device as follows:
• With the DC connection cable to a DC power supply in the vehicle
• With the AC connection cable to an AC power supply
Never pull the plug out of the socket by the cable.
If the cooling device is connected to a DC outlet, disconnect the cooling device and other power
consuming devices from the battery before connecting a quick charging device.
If the cooling device is connected to a DC outlet, disconnect the cooling device or switch it off when
turning off the engine. Otherwise the battery may be discharged.
The cooling device is not suitable for transporting caustic materials or materials containing solvents.
The insulation of the cooling device contains flammable cyclopentane and requires special disposal
procedures. Deliver the cooling device at the end of its life-cycle to an appropriate recycling center.
Do not place the cooling device near open flames or other heat sources (heaters, direct sunlight, gas
ovens, etc.).
Risk of overheating! Ensure at all times that there is a minimum of 50 mm (1.97 in) ventilation on all
sides of the cooling device. Keep the ventilation area free of any objects that could obstruct the air flow
to the cooling components. Do not use or store the cooling device in closed compartments or areas
with none or minimal air flow.
Do not fill the inner container with ice or fluids.
Never immerse the cooling device in water.
Protect the cooling device and cables against heat and moisture.
The cooling device shall not to be exposed to rain.
CFX5 EN
5
Publicité
