Publicité
General Power Tool Safety Warnings
ture is between +50 °F (10 °C) and +95
°F (+35 °C). If the battery pack is too hot
or too cold, the charger will not begin
charging the battery. (This may happen if
the battery pack is hot from heavy use).
Once the battery temperature returns to
its safe charging temperature, between
+50 °F (+10 °C) and +95 °F (+35 °C), the
charger will automatically begin charging.
2. A substantial drop in operating time per
charge may mean that the battery pack
is nearing the end of its life and should
be replaced.
3. Remember to unplug charger during
storage period.
The manufacturer is not responsible for radio
interference caused by unauthorized modi-
fications to this equipment. Such modifica-
tions could void the user's authority to oper-
ate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful interfer-
ence, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE! This equipment has been tested and
found to comply with the limits for a Class
B digital devices, pursuant to Part 15 of the
FCC rules. These limits are designed to pro-
vide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation
is subject to the following two conditions:
(1) this device may not cause interference,
and
4
1605A002SR GBA37V30 202406.indd 4
page heading
FCC Caution
Industry Canada (IC)
This class B digital device complies with ICES-003
Canada ICES-003(B) / NMB-003 (B)
SAVE THESE INSTRUCTIONS
4. If battery does not charge properly:
a. Check for voltage at outlet by plug-
ging in some other electrical device.
b. Check to see if outlet is connected to
a light switch which turns power "off"
when lights are turned off.
c. If you still do not get proper charging,
take or send tool, battery pack and
charger to your local Bosch Service
Center. See "Tools, Electric" in the Yel-
low Pages for names and addresses.
Note: Use of chargers or battery packs not
sold by Bosch will void the warranty.
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio com-
munications. However, there is no guarantee
that interference will not occur in a particu-
lar installation. If this equipment does cause
harmful interference to radio or television re-
ception, which can be determined by turning
the equipment off and on, the user is encour-
aged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the re-
ceiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
(2) this device must accept any interference,
including interference that may cause unde-
sired operation of the device.
6/3/24 10:43 AM
Publicité
