Publicité
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set louver at too vertical an angle for long periods of time. This can
cause water to condense on the louver blade, which will drop on your floor or furnishings.
When using COOL or HEAT mode, setting the louver at too vertical an angle can reduce the performance of
the unit due to restricted air flow.
Setting horizontal angle of air flow
The horizontal angle of the airflow must be set manually. Grip the deflector rod (See Fig.B)
and manually adjust it to your preferred direction. For some units, the horizontal angle of the airflow can
be set by remote control. please refer to the Remote Control Manual.
Manual Operation(without remote)
CAUTION
The manual button is intended for testing purposes and emergency operation only. Please do not
use this function unless the remote control is lost and it is absolutely necessary. To restore regular
operation, use the remote control to activate the unit. Unit must be turned off before manual
operation.
To operate your unit manually:
1.
Open the front panel of the indoor unit.
2.
Locate the MANUAL CONTROL button on the right-hand side of the unit.
3.
Press the MANUAL CONTROL button one time to activate FORCED AUTO mode.
4.
Press the MANUAL CONTROL button again to activate FORCED COOLING mode.
5.
Press the MANUAL CONTROL button a third time to turn the unit off.
6.
Close the front panel.
Range
NOTE: Do not move louver by hand. This will cause the louver to become out of sync. lf this occurs, turn off
the unit and unplug it for a few seconds, then restart the unit. This will reset the louver.
CAUTION
Do not put your fingers in or near the blower and suction side of the unit. The high-speed fan
inside the unit may cause injury.
4
64
Fig. A
Publicité
