Parkside PASL 4000 B3 Instructions D'utilisation Et Consignes De Sécurité page 9

Flush immediately the affected areas
with fresh water and seek medical
attention!
WEAR PROTECTIVE GLOVES!
Leaked or damaged batteries/
rechargeable batteries can
cause burns on contact with the skin.
Wear suitable protective gloves at all
times if such an event occurs.
This product has a built-in rechargeable
battery which cannot be replaced by
the user. The removal or replacement
of the rechargeable battery may only
be carried out by the manufacturer or
their customer service or by a similarly
qualified person in order to prevent
hazards. When disposing of the product,
it should be noted that this product
contains a rechargeable battery.
Before use
Note: Remove all packaging materials
from the product.
Charging the product
Note: The product cannot be charged at
temperatures below 0 °C and above 45 °C
according to the battery protection.
Note: You can charge the product from an
ordinary domestic mains power outlet, by
using the supplied USB cable
SELV adaptor . It takes approx. 6–8 hours.
12
Note that the integral rechargeable battery
must be charged before using the product.
The rechargeable battery is firmly integrated
into the base of the product.
Note: It is recommended to use the prod-
uct within 3 months after purchase.
Note: Fully charge the product before first
use.
Note: Fully charged the battery before
storage. If you wish to store the product
for longer than 3 months, fully charge the
battery every 3 months.
Note: You can choose to charge the prod-
uct directly via the SELV adaptor
the charging station.
Before charging, switch the product off
(press ON/OFF switch
To charge the product via SELV adap-
tor
cover at the back of the product, con-
nect the USB cable
connector of the SELV adaptor
then connect the USB (type C) connec-
tor on the USB cable
(type C) input socket
To charge the product via the charging
station, connect the USB cable
with the USB connector of the SELV
adaptor
(type C) connector on the USB cable
to the USB (type C) input socket of the
charging station
product into the charging station to
charge the product (see fig. B).
Note: The power indicator of the
charging station
when electrical power is connected. It
will light up red continuously until the
power is disconnected.
Note: The product is fitted with an
overcharge protection circuit. Despite
this, you should disconnect the LED
inspection lamp from the power supply
after the charging process is complete.
and the Note: The green charging indicators
11
(LED torch)
during charging. There are 4 indicator
lights showing the charging progress
(approx. 25 % /50 % /75 % /100 % ).
When the indicator continually light on
mean the represented charging progress
was finished. When charging is complete,
all indicator light up without flashing.
Pull the SELV adaptor
socket. Disconnect the SELV adaptor
from the product to prevent the re-
chargeable battery from discharging.
directly, remove the red rubber
12
11
11
6
and then connect the USB
12
. Then place the
10
will turn to red light
9
will light up and flash
4
12
or via
12
).
3
with the USB
and
12
to the USB
of the LED torch.
11
11
out of the
12
GB/IE/NI 9