Parkside PASL 4000 B3 Instructions D'utilisation Et Consignes De Sécurité page 10

Use
CAUTION! RISK OF ACCIDENT! Al-
ways store and secure the product in such
a way that there is no risk of injury from or
damage to the product.
Note: The product may be secured with
the fold-out hook
flat, ferromagnetic surface using the mag-
netic base or the magnet
8
You can tilt the product up to 180 ° on the
magnetic base .
8
CAUTION! Please note the position of your
hands whilst turning the magnetic base
to prevent pinching your fingers (see fig. D).
Operation
Fully charge the product as described
in the section "Charging the product".
The product can be operated in
3 different modes. You can select
these as follows by repeatedly press-
ing the ON/OFF switch
Press once:
Press twice:
Press three times: Switches the side
Press four times: Switches off the
Fixing the product
The product can be used in 2 ways
without having to hold it in your hand:
Hold the magnet
magnetic base
10 GB/IE/NI
or by securing it to a
5
at the back.
7
:
3
The side light
2
lights up with white
light.
The side light
2
turns to UV light
mode.
light off and
2
switches on the
spotlight .
1
product.
at the back or the
7
against a metallic
8
magnetic surface. The product
remains in this position.
Fold out the fold-out hook
the product from a suitable suspension
point. The fold-out hook
turned through 360 degree.
Note: When hanging up the product, it
must be ensured that the selected location
is suitable for the weight of the product.
Mounting the charging
station (see fig. C)
8
Note: You will need an electric drill.
CAUTION! RISK OF INJURY! Please read
the operating instructions for your drill.
CAUTION! Ensure that you do not damage
any electricity cables in the wall or ceiling.
Mark the two mounting holes at a
distance of approx. 35.5 m m apart.
Now drill the holes on the wall (ø ap-
prox. 6 m m; depth approx. 30 m m).
Insert the dowels
holes. If necessary use a hammer to
make this easier.
Screw up the screws
dowels .
15
Now hang the charging station to the
screws via the mounting holes
Use the included drill template in-
tended for marking the drill holes.
Maintenance and cleaning
The product requires no maintenance. The
LEDs cannot be replaced.
Switch off and disconnect the product
from the power supply before you
clean it.
Never immerse the product in water or
other liquids.
Do not use corrosive cleaning agents.
to suspend
5
can be
5
into the drilled
15
on the
14
.
13