Publicité
Istruzioni telecomando SL3192 - art. MARK56.indd 21
Istruzioni telecomando SL3192 - art. MARK56.indd 21
2) Release the button
3) The LED continues to flash for a few seconds. Wait
for it to turn off
4) All previously stored channels are deleted.
WAKE-UP FUNCTION AND DEACTIVATION
If the remote control is used together with SL2776
battery modules, it is necessary for the remote con-
trol to wake the battery modules from stand-by mode
before sending commands. This function is active as
standard and is identified by the "ScreenLine" ani-
mation on the display when the battery modules are
woken up and every time the remote control deems
that a specific channel has the battery modules in
stand-by status.
If only SL3163 control units are used and the systems
are not battery-operated, this function can be remo-
ved so that the blinds can be controlled immediately
without waiting for the "ScreenLine" animation.
To deactivate the "wake-up" function, follow the
steps below:
1) Select channel 32
2) Press the "ALL" and "STOP" buttons simultaneously
until you see the word "ALL" appear on the display
To reactivate the "wake-up" function, follow the steps
below:
1) Select channel 32
2) Press the "ALL" and "STOP" buttons simultaneously
until you see the "ScreenLine" logo appear
BATTERY REPLACEMENT INSTRUCTIONS
The system is designed to ensure long battery life.
When the batteries are exhausted, the following
symbol will appear on the display:
21
21
14/05/24 17:46
14/05/24 17:46
Publicité
