Publicité
5. DEVICE DESCRIPTION
The associated drawings are shown on page 3.
Cu
1
Cu connector
3
Risk indicator
5
7
Settings button
Function buttons < / >
9
Connection for mains
11
adapter
Information on the display
Time and date
12
Diastolic pressure
14
Calculated pulse value
16
AFib
18
Resting indicator display
20
Multiple measurement
22
Memory space number
24
Cu line
2
Connection for cu con-
4
nector (left-hand side)
Slider for user selection
6
START/STOP button
8
Memory button
10
Systolic pressure
13
Risk indicator
15
Cardiac arrhythmia symbol
17
/
Pulse symbol
User memory
19
21
Cu position control
OK
Memory display: average
23
value
, morning
evening
25
Low battery indicator
6. USAGE
6.1 Initial use
Inserting the batteries
• Remove the battery compartment cover on the back of the
device
.
A
• Insert the batteries (see chapter "Technical specifications").
Insert the batteries, making sure the polarity is correct accord-
ing to the label
.
A
• Close the battery compartment cover.
If the
symbol is displayed and does not disappear, meas-
urement is no longer possible. Replace all the batteries. Once the
batteries have been removed from the device, the date and time
must be set again. Any saved measured values are retained.
Operation with the mains part
You can also operate this device with a mains part (not included in
delivery). However, before connecting the device with the mains
part, please ensure that you have removed the batteries from the
device. During mains operation, there must not be any batteries in
the battery compartment, as this could damage the device.
• To avoid any potential damage, the device may only be oper-
ated with a mains part that meets the specifications described
in the chapter "Technical specifications".
• Furthermore, the mains part must only be connected to the
mains voltage that is specified on the type plate.
,
• Insert the mains adapter into the connection provided for this
purpose on the rear side of the blood pressure monitor.
• Then insert the mains plug of the mains part into the mains
socket.
• After using the blood pressure monitor, unplug the mains part
from the mains socket first and then disconnect it from the
26
Publicité
