Metabo C3607DA Instructions De Sécurité Et Mode D'emploi page 22

English
8. Attaching the guide (sold separately)
Install the wing bolt (B) and lock spring on the base.
Insert the guide into the base, move it left and right
and adjust the cutting position. Tighten the wing bolt
(B) and fi x the guide. The guide can be installed either
from the left or the right side of the main body.
Wing Bolt (B)
Lock
Spring
Base
Wing Bolt (B), Lock Spring
Fig. 29
WARNING
When using the guide, avoid inclined cutting that
will allow the cut material to be caught between
the saw blade and the guide. Doing so may result
in injury.
Saw blade
9. Cutting procedures
CAUTION
● Recheck that the saw blade is securely clamped.
● Confi rm that the lever for adjusting the angle of
inclination and the lever for adjusting the slot
depth are adjusted correctly.
22
Fig. 28
Base
Guide
(Rip Fence)
Lumber
Guide
Fig. 30
(1) Place the base on the material, then align the
premarked line and the saw blade with the notch at
the front of the base (Fig. 31).
When
Inclined 45°
(2) When the base is not inclined, use the right side of the
notch (Fig. 31, Fig. 32).
If the base is inclined (45 degrees), use the left side of
the notch (Fig. 31, Fig. 33).
When not
Inclined
Fig. 31
Fig. 32