Metabo C3607DA Instructions De Sécurité Et Mode D'emploi page 21

6. How to use the LED light
By pressing the light selector switch on the switch
panel, the LED light mode changes as Table 6. It is
indicated by green lamp. (Fig. 26)
To prevent the battery power consumption, turn off the
LED light frequently.
Lighting mode indicator lamp
Switch panel
LED Light
Always-ON
mode
Panel
display
Always ON
(turn off after
2 minutes)
State
Safeguard Function
Overload protection
Overheat protection
Light section
switch
Fig. 26
Table 6
SW Always-OFF
interlocked mode
mode
Light only Always OFF
SW-ON
(Automatically
goes out
approximately
10 seconds
after the
switch is
released)
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
CAUTION
Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 2 minutes.
7. LED light warning signals (Fig. 27)
This product features functions that are designed
to protect the tool itself as well as the battery. While
the switch is pulled, if any of the safeguard functions
are triggered during operation, the LED light will blink
as described in Table 7. When any of the safeguard
functions are triggered, immediately remove your
fi nger from the switch and follow the instructions
described under corrective action.
Table 7
Remove the cause of the overburdening.
Allow the tool and battery to thoroughly cool.
English
Fig. 27
Corrective Action
21