Controls & Functions; Operation Description - Ibiza Light SCAN500RGB Manuel D'utilisation

Console Light1
DESCRIPTION
1. Built-in performance programs, AUTO, SOUND
2. DMX mode
3. Master/Slave
4. ILDA DB25 mode
CONTROLS & FUNCTIONS
FUNC
Mode/Function: Set the operating mode of laser.
: Confirms all settings or changes of LED control panel.
ENTER
DOWN
UP / : Changes the operating mode, parameter or DMX address.
SET THE FUNCTION OVERVIEW:
[FUNCTION] key:
At every short press on the FUNC button, following actions are active :
•
INDR - DMX (5-CH simplified DMX mode) + you can set the DMX address via the UP/DOWN buttons and confirm
with ENTER
•
DMX (34-CH advanced DMX mode) + you can set the DMX address via the UP/DOWN buttons and confirm with
ENTER
•
INDR SE (1 – 2 – 3) = 3 AUTO or sound-controlled mode. The ENTER button toggles between these 2 modes
(SND is displayed)
The SE 1 sequence (beam/tunnels, waves mode) – SE 2 (animation 1) – SE 3 is accessible via the sub-menu.
To access the sub menu keep the FUNC button pressed for at least 3 seconds. SET is displayed on the bottom
right side of the display. You are now in the setting menu.
Select the sequence by selecting SE and press ENTER.
This sub-menu also allows to (not recommended for beginners!)
•
Configure motors X & Y via dr – X and dr – Y
•
Invert motors (SWAP XY)
•
Set the projection size (X-SIZ with values from 0 to 100 and Y-SIZE with values from 0 to 100)
•
Activate/deactivate the remote control ( REMOTE – ON/OFF)
To leave the menu, keep FUNC pressed.
4
MANUAL - SCAN Laser Systems
Light2 Light3

OPERATION DESCRIPTION:

©Copyright LOTRONIC 2019