Publicité
Changing the application mode
What's the application mode?
The application mode is the variation of the driving rotation
and impact which are already preset in the tool. By choos-
ing a suitable application mode depending on the work, you
can accomplish quicker work and/or more beautiful finish.
This tool features following application modes:
Impact force
•
Max
•
Hard
•
Medium
•
Soft
Assist type
•
Wood mode
•
Bolt mode
•
T mode (1)
•
T mode (2)
The application mode can be changed by the but-
ton
,
, or the quick mode-switching button.
► Fig.7: 1. Quick mode-switching button
2. Button
By registering a certain application mode to the tool, you can
switch to the registered application mode by just pressing the
quick mode-switching button (quick mode-switching function).
NOTE: When none of the lamp on the panel is lit, pull the switch
trigger once before pressing the quick mode-switching button.
NOTE: You will not be able to change the application
mode if you do not operate the tool for approximately one
minute. In this case, pull the switch trigger once and press
the
button,
button, or quick mode-switching button.
NOTE: Refer to "Registering the application mode"
in "Quick mode-switching function" section for how to
register the application mode.
Quick mode-switching button
The function of the quick mode-switching button varies depending
on whether you have registered the application mode to the tool.
► Fig.8: 1. Quick mode-switching button
When the application mode is not registered:
The level of impact force changes every time you press
the quick mode-switching button. The front lamps on
both sides will flash once when the impact force is
changed by pressing the quick mode-switching button.
When the application mode is registered:
The tool switches between the registered application
mode and current application mode every time you
press the quick mode-switching button. The front lamps
on both sides will flash once when the application mode
is changed by pressing the quick mode-switching button.
NOTE: When the lamp status is off, the lamps will not
flash even when the application mode is changed by
pressing the quick mode-switching button.
NOTE: Refer to "Registering the application mode"
in "Quick mode-switching function" section for how to
register the application mode.
3. Button
Disabling the quick mode-switching
button
You can also disable the quick mode-switching button.
After disabling, the quick mode-switching button will not
work for changing the impact force and switching the
application mode.
To disable the quick mode-switching button, press and
hold the quick mode-switching button and the but-
ton
at the same time until the all lamps on the panel
blink.
To resume the quick mode-switching button, perform
the same procedure as above again.
NOTE: Registering and erasing the application mode
can be performed even if the quick mode-switching
button is disabled. After registering or erasing the
application mode, the quick mode-switching button
will be activated.
Quick reference
The following table shows the functions of the quick
mode-switching button.
indicates the quick mode-switching button.
Button(s) / Purpose
+
Registering the application
mode
(When quick mode-switch-
ing function is OFF)
Changing the impact force
by the quick mode-switch-
ing button
(When quick mode-switch-
ing function is ON)
Switching to the registered
application mode
+
Erasing the registered
application mode
+
Disabling/resuming the
quick mode-switching
button
9 ENGLISH
How to confirm
The customize lamp and the
lamp of desired application
mode blinks.
The lamps on the tool flash
once.
The lamps on the tool flash
once.
The customize lamp and all
impact force grade lamps
blink.
All lamps on the panel blink.
Publicité
