Publicité
m
CAUTION! Change the temperature limiter
setting only after the tap has been installed.
Follow Fig. I to set the temperature limitation.
Turn off the main water supply.
Remove the chrome cap
small flat screwdriver.
Release the locking screw
anticlockwise using the hexagonal key
m
CAUTION! Do not take the screw
completely out; just loosen it until the control
lever
can be easily taken off.
1
Take off the control lever
Loosen the cartridge covering ring
hand, then screw off the cartridge retaining
ring
by using a pipe wrench.
21
Now pull the adjusting ring
the help of a screwdriver.
Note: Do not remove the cartridge
Place the adjusting ring
position (see Fig. I).
Tighten the cartridge retaining ring
the tap body
again by using a pipe
5
wrench. Then tighten the cartridge covering
ring
by hand.
20
Place the control lever
tap body
. Tighten the locking screw
5
by turning it clockwise using the hexagonal
key
.
7
Press the chrome cap
Turn on the main water supply and check the
temperature limiter.
carefully by a
3
by turning it
2
.
7
2
.
1
by
20
upwards with
22
.
23
in the desired
22
onto
21
back on to the
1
2
into the opening.
3
˜ Water-saving function
The cartridge
in this tap has an Eco-Click
23
function. This feature limits the water flow
through the tap. This means you can save up
to 50 % water (see Fig. J).
Lift the lever until you notice a slight
resistance. This resistance will cause a stop
in case of partial opening and will therefore
simply limit the flow of water.
If you want to increase the flow rate,
exert slight pressure on the lever until you
overcome the resistance.
˜ Energy-saving function
The cartridge
in this tap has an energy
23
function.
Only cold water will flow out when the
control lever
is set to the middle position,
1
and thus reduce energy consumption (see
Fig. K).
˜ Maintenance and cleaning
˜ Tap care and cleaning
Please note that sanitary fittings require special
care and attention. Therefore you should follow
the following advice:
Never use corrosive or alcohol-based
materials for cleaning, as these could
damage the product.
Clean your fittings with clean water, mild
detergent and a soft cloth or leather only.
Screw out the aerator
and remove lime deposits or foreign bodies.
Non-observance of the above care advice can
be expected to result in damage to the surface
of the fittings. In this event your rights under the
warranty may be invalidated.
at regular intervals
24
GB/IE/NI
7
Publicité
