Publicité
TROUBLESHOOTING
Fault
Light on, but motor does
not work.
Both light and fan do not
work.
Oil leakage.
Insufficient suction
The suction power is
insufficient.
Notes:
Any electrical repairs to this appliance must conform to your local, state and
federal laws. Please contact the service centre if in any doubt before undertaking
any of the above. Always disconnect the unit from the power source when opening
the unit.
Possible Cause
Fan switch turned off.
Fan switch failed.
Motor failed
House fuses blown
Mains power cable is
loose or disconnected
One way valve and the
outlet are not tightly
sealed
Leakage from the con-
nection of chimney and
cover
The distance between
the cooker hood and
the gas top is too far.
The distance between
the cooker hood and
the gas top is too far
Solution
Select a fan switch
position.
Contact service centre.
Contact service centre.
Reset/Replace fuses.
Refit mains power cable
to power outlet.
Take down the one
way valve and seal with
sealant.
Take chimney down and
seal.
Refit the cooker hood to
the correct distance.
Refit the cooker hood to
the correct distance.
EN
35
Publicité
