Publicité
CLEANING AND MAINTENANCE
Unplug the extractor hood before cleaning or servicing.
•
Clean the surface of the hood regularly. Use mild soap or detergent to clean
the hood.
•
Do not use aggressive alkaline solutions or abrasive cleaners.
•
Avoid using abrasive cleaners or dishwashing detergents.
•
The grease filter can be washed out with mild soap or a mild detergent.
(Heavy grease deposits may be difficult to remove and the filter may need to
be replaced).
•
The activated carbon filter cannot be cleaned and must be replaced regularly.
Note: The cleaning water must not penetrate into the electrical parts of the motor,
control switch, etc.
Stainless steel
The stainless steel must be cleaned regularly (e.g.weekly) to ensure a long life
expectancy.Dry with a clean soft cloth. A specialized stainlesssteel cleaning fluid
may be used.
Control panel surface
The inlay control panel can be cleaned using warmsoapy water. Ensure the cloth
is clean and well wrungbefore cleaning. Use a dry soft cloth to remove anyexcess
moisture left after cleaning.
Active and active charcoal filter replacement
Grease mesh grease filters (monthly cleaning)
•
The mesh filters can be cleaned by hand. Soak them for about 3 minutes in
water with a mild detergent and then brush it gently with a soft brush. Do
not apply too much pressure so as to avoid any damage to it . (Leave to dry
naturally out of direct sun light)
•
Filters should be washed separately to crockery and kitchen utensils. It is
advisable not to use rinse aid.
•
Remove the filter as shown in the following diagrams.
EN
33
Publicité
