Publicité
Island model installation
Position the hanging plate on the ceiling
and then mark the position of the screw
holes. The hanging plate should be securely
fixed to the ceiling.
(1) 11×ST4 (30 mm) screws for wooden
ceiling.
(2) 6×expansion bolts for cement ceiling.
Fix 4 angle bars to the hanging plate, insert
and tighten with 8 M5*10 screws.
Put and extend the another 4 angle bars
to the required height and fix them to the
existing angle bars with 16 M5*10 screws
and nuts and flat washers.
Notes
•
The angle bars must have an overlap of at least 100 mm.
•
The above angle bars are outside to cover below angle bars.
Tear off the film of chimneys and then put
the inner chimney outside the angle bars
and fix the inner chimney to the hanging
plate with 4 ST4*6 screws. Then put the
outer chimney outside the inner chimney
and use the hood to catch it.
EN
27
Publicité
