Bosch 3 601 E7A 0 Notice Originale page 8

8 | English
a)
(27) Pair of screw clamps
a)
(28) Extraction hose
Technical data
Hand-held circular saw
Article number
Rated power input
No-load speed
Max. speed under load
Max. cutting depth
– at a 0° mitre/bevel angle
– at a 45° mitre/bevel angle
Spindle lock
Base plate dimensions
Max. saw blade diameter
Min. saw blade diameter
Max. base blade thickness
Max. tooth thickness/offset
Min. tooth thickness/offset
Locating bore
Weight according to EPTA-Procedure 01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
When switching on power tools with starting current limitation, the voltage drops briefly. Interference with other equipment may occur in the
event of unfavourable conditions in the electricity supply. Malfunctions are not expected if the impedances in the electricity supply are below
0.25 ohms.
Fitting
Only use saw blades the maximum permitted speed of
u
which is higher than the no-load speed of the power
tool.
Inserting/changing the circular saw blade
Pull the plug out of the socket before carrying out any
u
work on the power tool.
Wear protective gloves when fitting the saw blade.
u
Danger of injury when touching the saw blade.
Do not use abrasive wheels as the application tool un-
u
der any circumstances.
Only use saw blades that match the specifications
u
given in this operating manual and on the power tool.
Selecting the saw blade
You will find an overview of recommended saw blades at the
end of these operating instructions.
Removing the saw blade (see figure A)
To change tools, we recommend that you place the power
tool down on the front side of the motor housing.
– Press and hold the spindle lock button (5).
1 609 92A 6F9 | (26.02.2021)
(29) Handle (insulated gripping surface)
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
GKS 235
3 601 E7A 0..
W 2100
-1
min 5000
-1
min 3500
mm
mm
mm 383 x 170
mm 235
mm 230
mm
mm
mm
mm
kg
Do not press the spindle lock button (5) while the saw
u
spindle is moving. The power tool may become damaged
if this happens.
– Use the hex key (17) to undo the clamping bolt (18) in ro-
tational direction ➊.
– Swing the retracting blade guard (12) back and hold on
to it firmly.
– Remove the clamping flange (19) and the saw blade (20)
from the saw spindle (22).
Fitting the saw blade (see figure A)
To change tools, we recommend that you place the power
tool down on the front side of the motor housing.
– Clean the saw blade (20) and all the clamping elements
to be fitted.
– Swing the retracting blade guard (12) back and hold on
to it firmly.
– Place the saw blade (20) on the mounting flange (21).
The cutting direction of the teeth (direction of the arrow
on the saw blade) must match the rotational direction of
the arrow on the protective guard (1).
– Attach the clamping flange (19) and screw in the clamp-
ing bolt (18) in rotational direction ➋. Ensure that the
GKS 235
3 601 E7A 0..
2100
5000
3500
85 85
65 65
● ●
383 x 170
235
230
2.2 2.2
3.2 3.2
2.0 2.0
25 25.4
7.6 7.6
/ II / II
Bosch Power Tools