Publicité
E Using the Rubber Cushion (Optional)
(If there is an existing Rear Support Bracket on the fire wall of the car.)
Rear Support Bracket
Cover the Mounting Bolt © on the rear of the
(existing on the car)
unit with the Rubber Cushion (Optional); and
mount it into the existing Rear Support Bracket.
Rubber Cushion (Optional)
3. Install Trim Plate ©.
4.After
installation,
reconnect
the
negative (—) battery terminal.
a) Remove the removable face plate.
(= Page 20)
b) Remove Trim Plate @) with a screwdriver as
shown in the figure.
Screwdriver
c) Pull out the unit while pushing the two lock levers using the screwdriver. (œ Fig. 1, 2)
d) Remove the unit by pulling it with both hands. (œ Fig. 3)
Lock Lever
Fig. 2
eel
Bix
RTN
ENS
SZ
one
Lock Lever
PD
19
CQ-DF100U
Publicité
