Publicité
è At the MONO setting, the amount of interference heard when
weak signals are received from an FM broadcast station is sig-
nificantly decreased.
e At the LOCAL
setting, only strong signals of stations are
searched in seek turning, while at the LOCAL OFF setting, rela-
tively weak signals are also searched.
() FM broadcast
Press and hold [*})(MONO/LOC) in the tuner mode for more than
2 seconds to switch between the MONO and LOCAL modes. Each
time [*](MONO/LOC) is pressed, the display changes as follows.
MONO OFF/LOCAL OFF
—
MONO re
OFF
MONO OFFILOCAL ON
<
MONO ON/LOCAL ON
@) AM broadcast
Press and hold [*](MONO/LOC)
for more than 2 seconds
to
change the local mode as follows.
a
LOCAL OFF
—
LOCAL ON
Station Preset
FM1, FM2, FM3 and AM can save a maximum 6 stations each in
their preset station memories.
Manual Station Preset
(D Press [BAND] to select a desired band.
@ Use manual or seek tuning to find a station which ts to be pre-
set in the memory.
|
@) Press and hold one of the preset buttons [1] to [6] for more
than 2 seconds until the display blinks.
Press and Hoi
| MONO/LOCAL Selection
J
e
a
rc
D
if
Y
een,
em
`s `
= =
i
pine,
x
lins
W
M
Preset number
Note: You. can change the memory presetting by repeating
the above procedure.
Tuning in a Preset Station
Press the corresponding preset button [1] to [6] to tune in a preset
station.
Auto Station Preset
Select the band, press and hold [BAND](APM)
for more than
2 seconds (Auto Preset Memory).
è The 6 strongest available stations will be automatically saved in
the memory on preset buttons [1] to [6].
e Once
set, the preset stations are sequentially scanned
for
5 seconds each.
è Press the corresponding preset button for the broadcast you
want to listen to.
Caution: To ensure safety, never attempt to preset stations while you are driving.
11
CO-DF100U
Publicité
