Publicité
18
instal lation
G uide
(continued)
O Precautions
e When bending the mounting tab of the mounting collar with a screwdriver, be careful not to in-
jure your hands and fingers.
è We recommend you to wear gloves for installation work to protect yourself from injuries.
O Installation Procedures |
Note:
è Disconnect the cable from the negative (—) battery terminal.
1. Secure Mounting Collar @).
|
Insert Mounting Collar Q) into the dashboard, and bend the mounting tabs out with a screwdriver.
-r
sA"
-
-
-7
_
@) Mounting
Collar
« <
Lock Lever
Make sure that the lock
lever is flush with the
mounting
collar (not
projecting outward).
Dashboard
a) Check the electrical connections by referring to this operating instructions. (œ Page 22)
b} Connect Mounting Bolt ©, using a suitable wrench.
c) Insert Power Connector © to the unit.
d} Insert the unit into the Mounting Collar @ and push it in until a "click" is heard.
© Power Connector
© Mounting Bolt
Unit
Unit
e) Secure the rear of the unit to the car by one of the two recommended methods.
E Using Rear Support Strap ©
Fire wall of the car
Affix one end of Rear Support Strap @ to
@) Tapping Screw
/ 3mm |
the rear of the unit, and the other end to the
fire wall of the car, or some other metallic
area.
m
©) Hex. Nut
@) Rear Support
'
Strap
© Mounting Bolt
@ Mounting Collar
CQ-DF100U
Publicité
