Westfalia 316 192 300 107 Instructions De Montage page 21

Installation instructions:
Electrical System for Towing Hitch
Installing the electrical system
1. Disconnect the ground terminal of the battery.
2. If necessary, remove the following coverings and panels:
·
In the luggage trunk
Covering of the rear end plate
-
Covering of the right and left tail light
-
Right and left cover panels
-
Cover of the cable duct on the right side
-
· On the left-hand side of the vehicle
Access strips
-
Lower covering of C,- B- and A-pillars
-
Lower dashboard covering
-
3. On vehicles with PDC bore a 19-mm-hole for the cable duct in a suitable place on the
vehicle's rear end next to the already existing cable duct (Fig. 1/7).
On vehicles without PDC use the cable duct already existing on the right rear end of the
vehicle (Fig. 1/7).
4. Starting in the luggage trunk, lead the socket end of the cable harness through the cable duct
to the outside up to the socket holder plate (Fig. 1/3).
5. Fit the rubber grommet and insert it into the cable leadthrough (Fig. 1/7).
6. Fit the socket gasket and connect the cable harness to the socket housing in accordance with
the pin assignment plan (Fig. 1/3) and push the rubber grommet against the socket.
7. Screw the socket onto the socket holder plate (Fig. 1/3) using the supplied screws and nuts.
8. Secure the cable harness using cable ties.
Renault Espace 316 192 391 101 03/03 21