Technical Data - EINHELL HKL 2000 Mode D'emploi D'origine

Anleitung_HKL_2000_SPK7:_
3. Items supplied
Open the packaging and take out the equipment
with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Fan Heater
Original Operating Instructions
4. Intended use
The equipment is designed exclusively for use as an
additional heater in dry, closed rooms. It is designed
to be operated only when placed on the floor.
The equipment may only be used for the tasks it is
designed to handle. Any other use is deemed to be a
case of misuse. The user/operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications.
Our warranty will be voided if the equipment is used
in commercial, trade or industrial businesses or for
equivalent purposes.

5. Technical data

Rated voltage:
Heat output: 2000 W (1000 W / 2000 W)
Thermostat control:
Protection class:
Equipment dimensions: approx.:
14.07.2010 15:38 Uhr Seite 9
6. Before starting the equipment
The equipment can be used indoors in a free
standing position. Keep a minimum distance of 1 m
between the housing and walls, combustible
materials (furniture, curtains, etc.). The equipment
may only be used completely mounted and standing
vertically on a stable surface. It is prohibited to
operate the equipment on an instable surface (e.g. on
a bed).
Important. Before using the equipment for the first
time, check that the voltage supply is the same as the
voltage details set out on the rating plate.
Read the safety regulations in section 1.
When the equipment is used for the first time or after
a long period of rest it may emit an odor for a short
time. This is not a fault.
7. Operation
7.1 Topple cut-out
If the equipment topples during operation, it is
automatically turned off by the switch (Fig. 3/Item 5).
When the heater is placed upright again (the switch
(Fig.3/Item 5) must be activated), the equipment
restarts immediately.
7.2 Heat output switches (Fig. 2):
Off setting (Item A)
Fan setting (Item B)
Low heating output (pos. C)
Maximum heating output (Item D)
7.3 Thermostat control (Fig. 1 / Item 3):
Switch on the required heating output. Turn the
control to "MAX" until the required room temperature
has been reached. Then turn down the control until
you hear a clear click. The thermostat control will
switch the radiator on and off automatically to
maintain the room temperature at an almost constant
level. However, this presupposes that the radiator has
sufficient output to cover the heating requirements for
230 V ~ 50 Hz
the room.
7.4 Overheating guard
Infinitely adjustable
In case of excessive heating, the heating function
II/
shuts down automatically. The fan and the indicator
24 x 28 x 11 cm light (Fig. 1/Item2) remain on.
If this occurs, turn off the equipment, disconnect the
mains plug and wait a few minutes for the equipment
to cool. After eliminating the cause (e.g. a covered air
GB
9