Publicité
NOTE: If the driver bit is not inserted deep enough
into the sleeve, the sleeve will not return to its original
position and the driver bit will not be secured. In this
case, try re-inserting the bit according to the instruc-
tions above.
NOTE: When it is difficult to insert the driver bit, pull
the sleeve and insert it into the sleeve as far as it will
go.
NOTE: After inserting the driver bit, make sure that it
is firmly secured. If it comes out, do not use it.
Installing hook
Optional accessory
The hook is useful to hang the tool. Install the hook to
the holes on the tool body.
► 1. Hook 2. Hole
OPERATION
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
Standard bolt
N•m
(ft•lbs)
120
(87)
100
(72)
80
(58)
2
60
(43)
40
(29)
20
(14)
1
1. Fastening time (second) 2. Fastening torque
High tensile bolt
2
N•m
(ft•lbs)
120
(87)
100
(72)
80
(58)
2
60
(43)
40
(29)
20
(14)
1. Fastening time (second) 2. Fastening torque
Hold the tool firmly and place the point of the driver bit/
socket bit in the screw head. Apply forward pressure
to the tool to the extent that the bit will not slip off the
screw and turn the tool on to start operation.
NOTICE:
the operation, rest the tool at least 15 min.
9 ENGLISH
M10 (3/8")
M8 (5/16")
0
1
2
1
M10(3/8")
M8(5/16")
0
1
2
1
If you use a spare battery to continue
M14 (9/16")
M12 (1/2")
M14 (9/16")
M12 (1/2")
M10 (3/8")
M8 (5/16")
3
M12(1/2")
M12(1/2")
M10(3/8")
M8(5/16")
3
Publicité
