Publicité
Changing the impact force
S H
1
S H
2
► 1. Hard 2. Soft 3. Changed in two steps 4. Pin hole
Impact force grade displayed
on panel
Hard
S H
Soft
S H
NOTE: When all lamps on the switch panel go out, the tool is turned off to save the battery power. The impact force
grade can be checked by pulling the switch trigger to the extent that the tool does not operate.
NOTE: While pulling the switch trigger, the impact force grade cannot be changed.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/socket bit
Optional accessory
12 mm
(15/32")
Use only the driver bit/socket bit shown in the figure. Do
not use any other driver bit/socket bit.
3
4
S H
Maximum blows
-1
3,900 min
(/min)
-1
3,300 min
(/min)
9 mm
(3/8")
You can change the impact force in two steps: hard and
soft mode.
This allows a tightening suitable to the work.
Every time the pin hole is pressed, the number of blows
changes in two steps.
You can change the impact force within approximately
one minute after releasing the switch trigger.
Purpose
Tightening when force and
speed are desired.
Tightening with less force to
avoid screw thread breakage.
1
► 1. Driver bit 2. Sleeve
To install the driver bit, pull the sleeve in the direction of
the arrow and insert the driver bit into the sleeve as far
as it will go.
Then release the sleeve to secure the driver bit.
To remove the driver bit, pull the sleeve in the direction
of the arrow and pull the driver bit out.
8 ENGLISH
Example of application
Tightening wood screws,
tightening bolts.
Tightening sash screws, tight-
ening small screws such as M6.
2
Publicité
