Publicité
4.5.3
Height adjustment
Important note!
Before adjusting the height of the bed, make sure that it is on its feet and has a secure footing. Otherwise the patient could in-
jure themselves.
Push or pull the all-round bar (1) down or up to move the lounger up and down.
Attention!
•
Make sure that there are no people or objects in the adjustment range of the bed.
•
The electrical functions are not suitable for continuous operation of more than 2 minutes. The built-in thermal protec-
tion switches the drive off automatically to prevent overheating. If this is the case, you must wait approx. 60 min. until
further operation is possible again. (Note the rating plate!)
4.5.4
Upholstery adjustment General
All gas spring-assisted adjustments can be set using a lever.
To set the desired position, move the lever (1) by pushing or pulling against the cushion (2).
Important note!
The back section may be loaded with a maximum of 100kg.
Datum: 17.10.2024
2
1
MultiPro® next
1
55 von 64
Publicité
