Kreg Jig K4 Guide D'utilisation page 3

3
K4 and K4 Master System Parts
A
Base
Features set-up gauges for positioning the stop collar on the drill bit. Includes four
holes for securing the jig to a workbench or other surface. A recess at the front of the
base accepts a clamp head for temporarily securing the jig to your workbench.
B
Drill-guide socket
Accepts all Kreg drill guides: Micro, Standard (included) and HD.
C Toggle clamp
Secures the workpiece to the jig.
D
Clamp pad
Adjusts to workpiece thickness.
E Standard drill guid
e
Features positioning marks for different workpiece thicknesses.
F Drill-guide locking pin
Locks the drill guide into the drill-guide socket at the selected setting.
Step bit
G
Simultaneously drills a pilot hole and clearance hole, forming a bearing shoulder
for the screw head.
H Stop collar
Fastens to the drill bit to control drilling depth.
I
Hex wrench
Tightens the stop-collar set screw. Stores in a recess at the rear of the base.
J Driver bit
#2 square-drive bit 6" (152mm) long.
Pocket-screw sample pack
K
Contains 10 each of the five most often used screws
Pocket-hole plug sample pack
L
Contains five paint-grade wood plugs
Additional Master System Parts
The K4 Master System includes the following parts
M
Portable base
Accepts Micro, Standard and HD drill guide blocks. Useful for large panels or
assemblies that would be difficult to clamp into a bench-mounted jig. Built-in cams
secure the portable base to your Kreg face clamp
N Workpiece support stop
Supports large workpieces and incorporates a swing-up, micro-adjustable workpiece
stop.
Parts
Additional Master System Parts
Vacuum port
O
Accepts a 1¼" (32mm) shop vacuum hose for efficient chip removal.
P Spacer block
In repair applications, positions the drill guide for drilling pocket holes in ¾" (19mm)-
thick material
Q Face clamp
Provides fast and secure clamping when assembling a pocket-screwed joint.
Driver bit
R
#2 square-drive bit 3" (76mm) long
Using the Kreg Jig
To create strong joints, you'll set your jig to match the
thickness of the workpiece and the length of the screw.
The Kreg Jig ® makes this easy, in just four simple steps:
1
Set the Drill Guide
For a strong joint, the screw should exit close to the centre
of the drilled workpiece. To adjust the pocket-hole position,
unscrew the drill-guide locking pin. Then align the mark on
the side of the drill guide that matches the thickness of the
workpiece with the top edge of the guide socket. Screw in
the locking pin.
2
Choose a Screw
Coarse Thread
Due to the large diameter and thread pitch,
our No.8 coarse-thread screws offer a
strong hold in softwoods and composite
materials.
Use in woods such as:
• Pine • Cedar • Basswood • Poplar
• Plywood • MDF • Particle Board
All Kreg pocket screws feature a deep square drive that improves driver engagement and reduces the
possibility of cam-out. The self-tapping auger point eliminates the need to drill a pilot hole.
Your KREG projects demand KREG Screws. Learn why at kregtool.com/kregscrews
Parts
K4 and K4 Master System
®
Fine Thread
Because the smaller diameter and thread
pitch of our No.7 fine-thread screws
reduce the chance of splitting the material,
we recommend them for hardwoods.
Use in woods such as:
• Ash • Oak • Maple • Walnut • Hickory
• Cherry • Mahogany • Birch
4