Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Flash-rate:
Number of LEDs:
Beam angle:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature T
Maximum housing temperature T
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Accessory:
FUTURELIGHT CP-240 controller
FUTURELIGHT CP-256/64 controller 16bit
FUTURELIGHT CP-512/64 controller 16bit
Wizard-512 USB DMX-Software + Interface
Wizard-1024 USB DMX-Software + Interface
FUTURELIGHT DES-3 DMX-terminator 3-pin
Please note: Every information is subject to change without prior notice. 25.09.2007 ©
100-240 V AC, 50-60 Hz ~
30 W
6/12/15
3-pin XLR
18 Hz
12
approx. 45°
420 x 225 x 80 mm
3.5 kg
:
45° C
a
(steady state):
65° C
B
0.5 m
0.1m
F 2 A, 250 V
No. 51834265
No. 51834288
No. 51834295
No. 51860102
No. 51860110
No. 51834001
29/55
00027030.DOC, Version 1.2