Télécharger Imprimer la page

Futurelight LB-12 LED-BAR Color Changer Mode D'emploi page 27

Publicité

Addressing
Depending on the DMX-mode (see table 4), each device of the FUTURELIGHT LB-12 LED-BAR occupies
15, 12 or 6 DMX-channels. If you select program "R ,G, B control per group" for example, the device
occupies 6 DMX-channels. To ensure that the control signals are properly directed to each device, it requires
adressing. This is to be done for every single device by changing the DIP-switches as set out in this table.
The starting address is defined as the first channel from which the FUTURELIGHT LB-12 LED-BAR will
respond to the controller.
Please make sure that you don't have any overlapping channels in order to control each FUTURELIGHT LB-
12 LED-BAR correctly and independently from any other fixture on the DMX data link. If two, three or more
FUTURELIGHT LB-12 LED-BARs are addressed similarly, they will work similarly.
Occupation des interrupteurs DIP:
DMX-512 connection / connection between fixtures
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
27/55
00027030.DOC, Version 1.2

Publicité

loading