Publicité
0.43 psi
(0.03 bar)
Operation
Q
Note: Before using the product for the first time,
check it carefully for holes, porous places and or
seams that are not airtight by adult.
Recommendation: Blow up the product and
leave it alone for one day. Air new products in the
open air for a few days.
Note: You will need a pump with conical adapter
(ø approx. 7.5 mm / 17.5mm) for the air valve
to inflate the product.
Letting in air
Q
CAUTION! Inflatable plastic products react sensi-
tively to the cold and hot. That is why you should
never use the product when the ambient temperature
falls to below 15 ° C and rises above 40 ° C.
Otherwise damage to the product may result.
Note: Basically, only an adult should be responsible
for pumping the product up. Make sure that you do
not pump too much air into the product. On no ac-
count should you use a compressor. Stop the process
when resistance increases during pumping and the
seams start to stretch. Otherwise the material might
No protection against
drowning.
Design working
pressure
3
tear. Only use manual pumps and / or pumps specifi-
cally designed for use with inflatable plastic products.
IMPORTANT! Keep in mind that air temperature
and weather conditions can affect the air pressure
inside inflatable products. In cold weather the prod-
uct behaves as if it has less air pressure in it because
the air inside contracts. Under these conditions you
may have to add air. In hot weather the air inside
expands. Under these conditions you may have to
remove air in order to avoid overfilling.
R oll the product out first and then check for
holes, tears and other damage.
Inflate all air chambers. The sequence is dis-
played on the valve.
Letting air out
Q
j
Open the air valve
the product.
Note: Make sure that the product is com-
pletely dry before folding it together. This will
prevent the formation mould, bad odours and
discoloration.
Cleaning and care
Q
j
U se a slightly damp, lint-free cloth to clean the
product.
j
O n no account should you use corrosive or
scouring detergents.
Storage instruction
Q
j
M ake sure that the product is completely dry
both inside and out when wishing to store it for
any length of time. Otherwise mildew and
mould may form.
j
S tore the product in dark, dry place – out of
reach of children.
j
T he ideal storage temperature is 10 - 20 °C.
j
E nsure that the product does not come into
contact with sharp objects during storage.
and let all the air out of
3
GB/IE/NI
9
Publicité
