Publicité
Attention!
• The hob must be installed by a qualified electrician in line with
all local standards and regulations for electrical wiring.
• Before any work on the electrical section of the appliance, it
must be disconnected from the mains.
• Connection to a good earth wiring system is absolutely essential.
• All supply current and earth conductors must be able to withstand
an ambient temperature of 75°C.
• After the hob is installed, the power switch must always be in an
accessible position.
The wires in the mains lead are coloured in accordance with
the following codes:
Green & Yellow = Earth
Blue & Grey = Neutral
Brown & Black = LINE
The appliance is equipped with a pre-connected electricity supply
cable without plug.
Separate the wires of the supply cable and connect them in
accordance with the instructions given in the below diagram.
1. The wie which is coloured green and yellow must be connected
to the terminal marked with the letter E (Earth) or with the earth
symbol
2. The wire which is coloured blue / grey must be connected to the
terminal marked N (Neutral).
3. The Brown and Black wires must be connected to the terminal
marked L (Line).
• If the appliance is being connected directly to the electricity
mains, an omnipolar circuit breaker with a minimum opening
of 3 mm between contacts must be fitted between the
appliance and the electricity supply in compliance with the
load and current regulations.
• The installer must ensure that the correct electrical
92
VH334T2 4 JUn.indd 92
VH334T2 4 JUn.indd 92
ELECTRICAL CONNECTION
or coloured green and yellow.
FR
NL
EN
PT
5/6/2024 9:25 AM
5/6/2024 9:25 AM
Publicité
