Measurement; Diopter Adjustment - Nikon COOLSHOT 20 Manuel D'utilisation

Measurement

Caution — use of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous radiation
exposure.
1. Install a battery in the battery chamber. (See
"Inserting and Changing Battery")

2. Diopter adjustment

Adjust diopter to obtain a clear LCD indication in the
viewfinder.
First, rotate the diopter adjustment ring counterclockwise
until it comes to a complete stop. Next, press the POWER
ON/Measurement button to turn on the power (Confirm
the internal display is on). While looking through the
eyepiece, rotate the diopter adjustment ring clockwise
until the LCD comes into focus.
If you rotate the ring too much, rotate it
counterclockwise substantially then adjust it again.
If the diopter is not adjusted to correspond to your
eyesight, you may not be able to correctly aim at your
subject.
3. Measuring
Before measuring, be sure to confirm unit setting.
1. Press the POWER ON/
Measurement button for
power-on.
Immediately after
power-on. (Initializing)
2. Aim at the target.
Stand-by. Target aiming.
3. Press POWER ON/Measurement button once to start continuous
measurement for approx. 8 seconds. (Single measurement mode is
not available with this laser rangefinder.)
Measuring.
4. For approx. 8 seconds, the internal display shows "distance" and "fail to
measure" indicator alternately. (Laser irradiation mark is blinking.)
Displays the
Displays the
measured figure. measured figure.
(Target 1)
5. After continuous measurement, the measured results are
displayed for approx. 8 seconds, then power turns off. If you
press the POWER ON/Measurement button during power-on
(while the internal display is active), another approx. 8-second
measurement starts.
Failure to measure or
unable to measure
distance.
(Target 2)
En
Es
Fr
Pt
13