Publicité
GENERAL ASSEMBLY INSTRUCTIONS
1
6
11
WARNING:
THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM. TO
REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the powerhead off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed on
page 8 (Fig. 4).
5. Turn the collection tank upside down and insert the four casters into the sockets on the bottom of
the base. Press casters down until they snap into place (Fig. 5).
6. Insert the handle into the slots located on the top of the powerhead (Fig. 6).
7. Your vacuum comes ready for dry vacuum cleaning. If the reusable cloth filter is not installed, refer
to page 15 for installation instructions (Fig. 7).
8. For wet vacuum cleaning, remove the reusable cloth filter, and install the supplied foam wet filter.
See page 16 for the foam wet filter installation instructions (Fig. 8).
9. Place the powerhead back on the collection tank, aligning the top section with the latches, and
snap into place (Fig. 9 & 10).
10. Insert the larger end of the hose into the vacuum port on the collection tank (Fig. 11).
11. Choose the desired accessory and insert onto the free end of the hose or extension wand (Fig. 12).
NOTE: An anti-static chain is attached to the bottom of the collection tank. It is normal for this chain to
drag on the ground. Operating the vacuum in dry conditions can build up static, and the chain helps
dissipate and build-up by allowing it a path of least resistance to the ground.
2
1
2
7
12
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE SURE
3
8
9
4
9
10
5
Publicité
