Publicité
LIQUID VACUUM OPERATION
1
6
LIQUID VACUUMING
WARNING:
ENTITLED "IMPORTANT SAFETY INSTRUCTIONS". DO NOT VACUUM IN AREAS WITH
FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE
GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS.
EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN
OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR
DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING:
THE PLUG IS DISCONNECTED BEFORE CHANGING THE FILTERS.
1. Verify that the power cord is disconnected from the outlet. Make sure that the collection tank is
clean and free of dust and dirt (Fig.1).
2. Remove the reusable cloth filter, then carefully install the foam wet filter over the filter cage and
place the powerhead back on the collection tank. For foam wet filter installation instructions, see
page 16 (Fig. 2 & 3).
DO NOT USE THE REUSABLE CLOTH FILTER FOR LIQUID VACUUMING.
OPERATING INSTRUCTIONS: WET VACUUMING
3. Insert the larger end of the hose into the vacuum port on the tank.
4. Push the required accessory onto the free end of the hose or the extension wand (Fig. 4).
5. Verify that the switch is in the 'O' OFF position before plugging the power cord into the outlet. Plug
the power cord into the outlet (Fig. 5 & 6).
6. Turn the motor on by flipping the switch to the 'I' ON position (Fig. 7).
7. Once you have completed vacuuming, flip the switch to the 'O' OFF position and unplug the power
cord from the outlet.
8. After use, empty the collection tank, clean and dry the inside and outside before storage (Fig. 8).
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely in
the liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine is fitted with a
2
7
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE SURE
3
8
12
8
4
5
Publicité
