Publicité
float valve that stops the suction action when the collection tank reaches its maximum capacity. You
will notice an increase in motor speed. When this happens, turn off the machine, disconnect from
power supply, and drain the liquid into a suitable receptacle or drain. To continue vacuuming, refit the
powerhead to the collection tank. After wet vacuuming, turn the machine off and remove plug from
power supply. Empty the collection tank, clean and dry the inside and outside before storage.
REMEMBER! The foam wet filter must be removed after wet vacuuming and the reusable cloth filter
must be installed before dry vacuuming again.
This Wet/Dry Vacuum has blowing capabilities. To use the blower feature, follow the instructions listed
below.
WARNING:
CANADA, CSAZ94.3) BEFORE USING BLOWER.
CAUTION:
WARNING:
INHALED.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Make sure the collection tank is empty before using as a blower. Clear all dirt and debris from the
hose and collection tank.
3. Remove hose from the vacuum port.
4. Insert the larger end of the hose into the blower port on the back side of the powerhead. (Fig. 2).
5. Choose the desired accessory and insert onto the end of the hose (Fig. 3).
6. Verify that the on/off switch is in the 'O' OFF position before plugging the power cord into the outlet.
Plug the power cord into the outlet (Fig. 4).
7. Before turning on the vacuum, firmly hold loose end of the hose. Turn the motor on by flipping the
switch to the 'I' ON position (Fig. 5).
8. Once you have completed blowing, flip the on/off switch to the 'O' OFF position. Unplug the power
cord from the outlet.
BLOWER OPERATION
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
4
13
5
Publicité
