Publicité
OPERATION
General
Use the following information and procedures to operate a
Hatco
Flav-R 2-Go
Locker System.
®
®
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
CAUTION
BURN HAZARD: Some exterior surfaces on unit will get
hot. Avoid unnecessary contact with unit.
Single-Sided Models
Single-sided models are equipped with one screen used by
both operators and customers. The default screen is the Order
Ready screen for customers. Touch the
passcode to switch/flip to the operator's Select Lockers screen.
The touchscreen will switch back automatically to the Order
Ready screen after 20 seconds of inactivity.
Startup
Use the following procedure to turn on the unit.
1. Move the Power On/Off switch to the "On" position. The
switch will illuminate when unit is turned on.
• The Power On/Off switch is located above the operator's
touchscreen controller on pass-through units and next
to the power cord on single-sided access units.
• The touchscreen, LED lights, and heating elements (if
enabled) will energize.
• After the software loads, the Select Lockers screen or
Welcome screen will appear, depending on the controller.
Red text indicates
locker is overtime.
White text indicates
time food is
in locker.
Locker is
disabled.
Flip Icon
(Single-Sided
Models Only)
Description of Select Lockers Screen
CAUTION
BURN HAZARD: Some exterior surfaces on the unit will
get hot. Use caution when touching these areas.
2. Allow the heated lockers 30 minutes to reach operating
temperature.
• The factory setpoint temperature is 150°F.
3. Refer to the "Placing an Order" procedure to input
customer order information and place food into a locker.
Shutdown
1. Move the Power On/Off switch to the "Off" position and
2. Perform the "Daily Cleaning" procedure in the
NOTE: If unit is shutdown with active orders, the orders will be
Placing an Order (Operator Side)
Use the following procedure to place a completed and packaged
customer order into a locker for holding. This procedure is for
units using the default "Name/Code" Claim Mode setting. For
other Claim Mode setting information, refer to the appropriate
Claim Mode setting at the end of this procedure.
icon and enter the
1. On the Select Lockers screen, touch the desired open
2. With the locker(s) selected, touch PLACE ORDER.
3. Type the name of the order and touch ENTER.
Order
Code
Locker is
heating.
4. Type the order code and touch ENTER.
Settings
Error
12
allow the unit to cool completely.
MAINTENANCE section of this manual.
saved for when the unit is turned back on, but the timer
will be reset. To clear orders refer to the "Clear a Single
Order" procedure in this section.
locker number(s).
• Up to four lockers can be selected if the food order will
not fit in one locker.
Enter Name Screen
• The order code can be up to 6 digits.
• The name will appear on the customer-side screen to
identify their order.
• The order code will be used by the customer to unlock
their locker(s).
English
F2GM-0424
Publicité
