Controls - Medline EntraFloH2O Guide D'utilisation

CONTROLS

5
KEYPAD CONTROLS
1. ON, turns power on, memory recalls
previous settings.
2. OFF, turns power off, battery
charges when plugged into
an electrical outlet.
3. SELECT, selects a delivery function
to display and/or change.
4. RESET, resets displayed value of
selected function to 0. (If FEEDING
RATE is selected, pressing and
holding RESET for 4 seconds will
reset all parameters to default set-
tings.)
5. increases feeding rate, dose
limit, feeding strength, water set
volume, or time interval when
pressed. Change is more rapid
when pressed and held.
6. decreases feeding rate, dose
limit, feeding strength, water
volume set, or time interval when
pressed. Change is more rapid
when pressed and held.
7. PRIME, automatically primes both
feeding and water through the
administration set.
8. RUN/PAUSE, starts and/or holds
pump operation. PAUSE is used to
temporarily stop feeding, or silence
an alarm condition. Parameters can
only be changed when pump is in
PAUSE mode. An audio and visual
alarm is activated if the pump has
been in PAUSE mode for 2 ½ min-
utes. Press RUN/PAUSE to resume
normal operation.
FEEDING/
HYDRATING
9
PAUSED
10
BATTERY
CHARGING
BATTERY
WATER
SET VOLUME
TIME INTERVAL
VOLUME
DELIVERED
ACCUMULATED
VOLUME
1
3
ON
SELECT
2
4
OFF
RESET
FUNCTION DISPLAYS
9. FEEDING/HYDRATING, PAUSED,
indicates status of the pump
when power is on.
10. BATTERY CHARGING, indicates
the unit is plugged into an electri-
cal outlet.
11. LOW BATTERY, indicates when
the battery charge is below
performance level.
12. Display panel, indicat es selected
parameter.
12
mL/hr
11
LOW
FEEDING
FEEDING RATE
VOLUME
DELIVERED
DOSE LIMIT
ACCUMULATED
VOLUME
STRENGTH
7
PRIME
5
8
RUN
6
PAUSE