Operating Instructions - Medline EntraFloH2O Guide D'utilisation

DETAILED OPERATING INSTRUCTIONS
Attach pump to IV pole using built-in
pole clamp. Plug power cord into a
120 VAC, 60 Hz. three wire grounded
electrical outlet if available.
PREPARE ENTRAFLO H20™
DELIVERY SET
1. Close both clamps on delivery
set prior to setup. Prepare and
hang EntraFloH20™ pump set
from an IV pole.
2. Open delivery set security doors
by pulling the latch on each
door.
3. Insert water drip chamber into
water side drip chamber brack-
et, and feeding drip chamber
into feeding side drip chamber
bracket.
4. Carefully stretch water set sili-
cone tubing around rotor. Insert
pump adapter into bridge. Place
tubing into tubing guide, close
and latch delivery set security
door.
5. Repeat step 4 with feeding side
delivery set.
CHECK PUMP SETTINGS
1. Press ON - alarm sounds briefly
.
8
and displays
has memory and displays pre-
vious settings, and returns to
flashing Feeding rate on the dis-
play panel.
Note: Changes can only be made to
parameters at the START of a new
feeding protocol to avoid improper
water delivery. To facilitate this
safety feature, parameters can only
be changed when amount displayed
in Volume Delivered is 0.
If desired, reset Volume Delivered
or reset all parameters to default
settings by pressing and holding
Reset for 4 seconds when Rate is
displayed.
2. Check Feeding Volume
Delivered. Press SELECT until
Volume Delivered is displayed.
If desired, reset to 0 by press-
ing RESET. This also resets
Water Volume Delivered to 0.
(Accumulated Volume is not
affected.)
3. Check Dose Limit. Press SELECT
until Dose Limit is displayed.
To change, press
or (decrease). For continuous
feeding where no dose limit is
desired, press
displayed.
4. Check Feeding Accumulated
Volume. Press SELECT until
Accumulated Volume is dis-
played. If desired, reset to 0 by
pressing RESET.
. . .
8 8 8. The pump
(increase)
until nOnE is
10