Publicité
Please use the foot caps, to keep the mat in an
upright position. Keep out of reach of children.
RUNNING BELT AND DECK LUBRICATION
This treadmill is equipped with a pre-lubricated, low maintenance deck system. The belt/ deck friction may play a
major role in the function and life of your treadmill, thus requiring periodic lubrication. We recommend a periodic
inspection of the deck. You need contact with our service center if you find the damage of the deck.
We recommend lubrication of the deck according to the following timetable:
Light user (less than 3 hours/ week) - Annually
Medium user (3-5 hours/ week) - Every six months
Heavy user (more than 5 hours/ week) - every three months
We recommend that you buy the lubrication from our distributor or directly to our company.
Attention: Any repair needs the professional technician.
1. We suggest that you should cut off the power for 10Mints after keep running 2HS, so that it's good for maintain the
treadmill.
2．The belt would slip if too loose during using；if the belt is too tight,it would affect the performance of motor and
increase the abrasion of roller and belt.The belt can be lift away from the deck for around 50 — 75mm if the degree
of tightness is just well.
Maintenance and Malfunction Treatment
1) The surface of the treadmill should be kept clean, pull out the power line
before cleaning. You can clean the running belt and the surface of the
treadmill with a soft and wet cloth.
2) The running belt is adjusted at factory; it may runs defectively after
transportation and use. Turn off the treadmill before adjusting, pull the belt in
the center, and then adjust the left and right bolts in rear roller with hex
spanner (See figure ) it is better to adjust 1/2 circle once. Then turn on the
switch, check if the belt
10 runs defectively when the running speed is 4~5 km/h.
It is strictly forbidden to run on or off the mat
during the exercise.
Publicité
