Publicité
POWER LIMIT function
It is possible to set at 50% of the radiator nominal value the AVERA-
GE power that can be delivered. This function is particularly useful, for
example, to reduce the maximum temperature of accessible surfaces
in the presence of vulnerable people or to reduce costs by accepting a
slower and less powerful heating.
8. Temperature control
The electronic temperature control is based on the value that the user assigns to the COMFORT temperature.
The temperature values for the Comfort-1, Comfort-2, Eco and Antifreeze modes are automatically calculated
and can not be directly modified by the user. The reference temperature is always indicated on the display together
with the symbol representing the selected operating mode.
NOTE: The temperature measured by the sensor inside the product always indicates the ambient temperature in the
immediate vicinity of the product and may differ from the temperature measured with other instruments in other areas
of the room. This difference may depend on various factors, such as:
- The installation position: some areas of the room may be affected by currents or warm air pockets that can change
the sensor measurement;
- The installation on an external perimeter wall, which is normally colder than internal walls, may result in a lower tem-
perature measurement than the actual room temperature;
- Unstable conditions: each evaluation must be made under stable operating conditions. For this reason the Comfort
temperature should not be changed before 60 minutes have elapsed since the previous modification. In fact, it is not
possible to assess whether the room temperature is correctly maintained by the product if the temperature level is
continuously modified in a short period of time.
If the difference between the set temperature and the ambient temperature is detected in stability conditions, calculate
this difference and then increase or decrease the comfort temperature level on the product of the exact calculated
difference value.
The function is disabled by default. To activate it, press
the
key. The display shows the writing "rEd1".
To deactivate it, press the
The display shows the writing "rEd0".
key.
26
Publicité
