Publicité
Electrical Connection
The cooker must be installed by a qualified electrician, in
accordance with all relevant British Standards/Codes of
Practice (in particular BS 7671), or with the relevant national
and local regulations.
Current Operated Earth Leakage Breakers
The combined use of your cooker and other domestic
appliances may cause nuisance tripping, so we
recommend that the cooker is protected on an individual
RCD (Residual Current Device) or RCBO (Residual Current
Breaker with Overload).
IF IN DOUBT, PLEASE CONSULT A SUITABLY
QUALIFIED ELECTRICIAN.
WARNING: THE APPLIANCE MUST BE EARTHED.
Note: The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
a suitable cooker control unit incorporating a double pole
switch, having a contact separation of at least 3mm in all
poles.
The cooker MUST NOT be connected to an ordinary
domestic power point.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect the
mains cable to the correct terminals for your electrical supply
type (Fig.7-9 and Fig.7-10). Check that the links are correctly
fitted and that the terminal screws are tight. Secure the mains
cable using the cable clamp.
Hob Check
Check each cooking zone in turn. Be sure to use pans of the
correct size and material.
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Set the clock as described earlier, and then turn on the ovens.
Check the oven fans start to turn and that the ovens heat up.
Fitting the Handles and Handrail
on model)
Remove the 4mm Allen screws from the doors (Fig.7-11). Fit
the door handles and secure using the 4mm screws.
The handles should be above the fixings.
Fit the plastic blanking plugs to the fixing holes (Fig.7-12).
Remove the 4mm Allen screws from the top corners of the
fascia (Fig.7-13). Fit the front handrail in position and secure
using the 4mm screws.
Check the appliance is electrically safe when you have finished.
(depending
INSTALLATION
�
�
���������
ArtNo.130-0010 Electrical connections single-phase
������������
��
�
��
��
��������
ArtNo.130-0010 Electrical connections 3-phase
�����
�������������
ArtNo.215-0026 - Handle gaskets fixed
ArtNo.215-0027 - Elan handle blanking plugs
Art No 215-0028 - Handrail fascia fixings
27
Fig.7-9
Fig.7-10
���������
Fig.7-11
Fig.7-12
Fig.7-13
Publicité
