Publicité
Make sure the switch is off and the battery
pack is removed.
Additional Safety Instructions
Personal protective equipment
1.
Clothing must be close-fitting, but must not
obstruct mobility.
2.
Wear the following protective clothing during
work:
•
A tested safety helmet, if a hazard is pre-
sented by falling branches or similar;
•
A face mask or goggles;
•
Suitable ear protection (ear muffs, custom or
mouldable ear plugs). Octave brand analysis
upon request.
•
Firm leather safety gloves;
•
Long trousers manufactured from strong
fabric;
•
Protective dungarees of cut-resistant fabric;
•
Safety shoes or boots with non-slip soles,
steel toes, and cut-resistant fabric lining;
•
A breathing mask, when carrying out work
which produces dust (e.g. sawing dry wood).
Operation
1.
Before starting work, check that the tool is in
proper working order and that its condition
complies with the safety regulations. Check in
particular that:
•
The run-down brake is working properly;
•
The bar and the sprocket cover are fitted
correctly;
•
The chain has been sharpened and ten-
sioned in accordance with the regulations.
Do not start the tool with the chain cover
2.
being installed on it. Starting the tool with the
chain cover being installed on it may cause the
chain cover to be thrown out forward resulting in
personal injury and damage to objects around the
operator.
3.
Do not stand directly under the branch that
is being cut. Pay attention to the falling
branches.
4.
Do not operate the tool in bad weather or if
there is a risk of lightning.
When you use the tool on muddy ground, wet
5.
slope, or slippery place, pay attention to your
footing.
Avoid working in poor environment where
6.
increased user fatigue is expected.
7.
Do not submerge the tool into a puddle.
8.
Do not leave the tool unattended outdoors in
the rain.
9.
When wet leaves or dirt adhere to the suc-
tion mouth (ventilation window) due to rain,
remove them.
10. Do not use the tool in the snow.
Maintenance and storage
Do not wash the tool with high pressure water.
1.
2.
When washing the tool, do not let water enter
the electrical mechanism such as battery,
motor, and terminals.
3.
Perform inspection or maintenance in a place
where rain can be avoided.
4.
After using the tool, remove the adhered dirt
and dry the tool completely before storing.
Depending on the season or the area, there is a
risk of malfunction due to freezing.
5.
When storing the tool, avoid direct sunlight
and rain, and store it in a place where it does
not get hot or humid.
Electrical and battery safety
1.
Avoid dangerous environment. Don't use the
tool in damp or wet locations or expose it to
rain. Water entering the tool will increase the
risk of electric shock.
2.
Do not dispose of the battery(ies) in a fire.
The cell may explode. Check with local codes for
possible special disposal instructions.
3.
Do not open or mutilate the battery(ies).
Released electrolyte is corrosive and may cause
damage to the eyes or skin. It may be toxic if
swallowed.
4.
Do not charge battery in rain, or in wet
locations.
5.
Do not charge the battery outdoors.
Do not handle charger, including charger plug,
6.
and charger terminals with wet hands.
7.
Do not replace the battery with wet hands.
8.
Do not leave the battery in the rain, nor charge,
use, or store the battery in a damp or wet
place.
9.
Do not wet the terminal of battery with liquid
such as water, or submerge the battery. If the
terminal gets wet or liquid enters inside of battery,
the battery may be short circuited and there is a
risk of overheat, fire, or explosion.
10. After removing the battery from the machine or
charger, be sure to attach the battery cover to
the battery and store it in a dry place.
11.
If the battery cartridge gets wet, drain the
water inside and then wipe it with a dry cloth.
Dry the battery cartridge completely in a dry
place before use.
SAVE THESE INSTRUCTIONS.
WARNING:
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
Important safety instructions for
battery cartridge
1.
Before using battery cartridge, read all instruc-
tions and cautionary markings on (1) battery
charger, (2) battery, and (3) product using
battery.
2.
Do not disassemble or tamper with the battery
cartridge. It may result in a fire, excessive heat,
or explosion.
3.
If operating time has become excessively
shorter, stop operating immediately. It may
12 ENGLISH
DO NOT let comfort or familiarity
Publicité
