Publicité
ENGLISH
The light does
not switch on
The device
suddenly
stops working
The oven does
not heat
Water leaks
out of the door
when using
the oven
The oven
stops working,
but the motor
does not
If the problem has not been solved:
1. Remove the oven from the mains (switch off or disconnect the fuse).
2. Contact the official Cecotec Technical Support Service. Do not try to repair the appliance
on your own.
BOLERO HEXA M236000
60
04725_04726_04727_04728_04729_04730_Horno Multifunción Bolero Hexa M236000.indd 60
04725_04726_04727_04728_04729_04730_Horno Multifunción Bolero Hexa M236000.indd 60
The light bulb is faulty.
There is no power supply.
There has been a power cut.
Thermostat failure.
You have not selected the
temperature.
The time knob is in the 0 position.
No power supply.
The heating element is damaged.
Door seal is damaged.
The hinge is not strong enough.
The oven has been running for a
long period of time, so it needs
time to cool down.
Thermostat failure.
Replace the light bulb.
Check if the oven is powered by
electricity.
Check the light in your kitchen or the
operation of another appliance.
Check if the fan is working. If this
is the case, replace the thermostat
with a new one by contacting the
official Cecotec Technical Support
Service.
Adjust the temperature.
Set the time knob.
Check the power supply box.
Replace the heating element with a
new one, to do so contact the official
Cecotec Technical Support Service.
Replace the door seal, to do so
contact the official Cecotec Technical
Support Service.
Replace the hinge, to do so contact
the official Cecotec Technical Support
Service.
Place your hand on the air outlet. If
you notice that the air comes out hot,
it is not a problem.
If you notice that the air comes out
at room temperature, replace the
thermostat, contact the official
Cecotec Technical Support Service.
26/4/24 10:01
26/4/24 10:01
Publicité
