Publicité
3. INSTALLATION
Before installation
-
The appliance must be installed in a built-in cabinet. A safety distance must be maintained
between the appliance and the kitchen walls.
-
In figure 3, you can see the dimensions (mm) required for the installation.
Surfaces, synthetic laminates, and adhesives used must be heat resistant (100 ℃
-
minimum) and adjacent furniture must be resistant to at least 70 ºC.
-
Kitchen cabinets must be level and fixed. A space of 5 mm must be left between the oven
and other appliances.
-
If there is a drawer under the oven, a shelf must be installed between the oven and the
drawer.
-
The door and/or handle must not be used to lift or move the appliance.
-
For installation, the appliance must be connected in accordance with all local gas and/or
electrical regulations.
-
Transport must be carried out by at least two people.
-
Use the slots or grips on both sides of the oven to carry the oven.
Mains connection
-
This appliance must be connected to an earthed socket.
-
Cecotec is not liable for any damage caused by the use of the appliance without an earth
connection. If the installation is not carried out professionally, there is a risk of electric
shock. The appliance must only be connected to the mains by an authorised qualified
person. If this is not the case, the warranty will be voided.
-
If the power cable is damaged, there is a risk of electric shock, short circuit, and fire. The
power cable must not be pinched, bent or trapped and must not come into contact with
hot parts of the appliance. If the power cable is damaged, it must be replaced by a qualified
electrician.
-
The mains supply must correspond to the information on the rating plate of the appliance.
The power cable must correspond to the specifications and power consumption.
Risk of electric shock
Before carrying out the electrical installation, make sure that the appliance is switched off and
disconnected from the mains.
Installation
1. Insert the oven through the hole in which it is to be placed, align it, and fix it in place.
2. Secure with 2 screws and washers as shown in figure 4.
Check
1. Connect the appliance to the mains and switch it on.
04725_04726_04727_04728_04729_04730_Horno Multifunción Bolero Hexa M236000.indd 51
04725_04726_04727_04728_04729_04730_Horno Multifunción Bolero Hexa M236000.indd 51
ENGLISH
51
BOLERO HEXA M236000
26/4/24 10:01
26/4/24 10:01
Publicité
