Publicité
ENGLISH
2. Check that the oven works.
Electrical connections
Ovens equipped with a three-pole power cable are designed to operate on alternating current.
The cable for the grounding of the device is yellow green.
Mounting the power cable
Opening the terminal box. (Fig. 5):
-
Using a screwdriver, prise the bolt on the side tabs of the terminal box cover.
-
Unscrew the screw and open the cover.
-
To install the cable, proceed as follows:
-
Remove the cable clamp screw and the three contact screws.
-
Fix the wires under the screw heads using the following colour scheme:
Blue - Neutral (N)
o
Brown phase connector (L)
o
o
Yellow-Green (Ground)
-
Secure the power cable with the cable clamp and close the terminal box cover.
Open the terminal box
-
With a screwdriver, tighten the screw on the side tabs of the terminal box cover.
-
Unscrew the screws on the side tabs of the cover and remove the latter.
Connecting the power cable to the mains
-
Install a standard plug (not included) corresponding to the load indicated on the rating
plate. When connecting the cable directly to the mains, install an omnipolar circuit
breaker with a minimum contact opening of 3 mm between the device and the mains.
The omnipolar circuit breaker must be sized according to the load and comply with the
applicable regulations (the earth wire must not be interrupted by the circuit breaker).
-
The power supply cable must be routed so that it does not reach a temperature above
50 ℃ above room temperature and must be protected by insulation with an appropriate
rating.
-
Before connecting, check the following:
-
The electrical safety of this appliance can only be guaranteed if the oven is correctly and
effectively earthed in accordance with electrical safety regulations. Always make sure
that the ground connection is effective; if in doubt, call a qualified technician to check the
system. Cecotec declines all liability for damage resulting from a system that has not been
grounded.
-
Before connecting the appliance to the mains, check that the specifications indicated on
the rating plate (on the appliance and/or on the packaging) correspond to those of the
mains supply at home.
-
Check that the electrical capacity of the installation and the sockets can withstand the
BOLERO HEXA M236000
52
04725_04726_04727_04728_04729_04730_Horno Multifunción Bolero Hexa M236000.indd 52
04725_04726_04727_04728_04729_04730_Horno Multifunción Bolero Hexa M236000.indd 52
26/4/24 10:01
26/4/24 10:01
Publicité
