Publicité
ENGLISH
make sure that the locking rod is closed at all times. It should only be open when the door
is removed.
Disassembling the door
1.
Open the door completely.
2.
Lift both sides of the locking rod as shown in Figure 7.
3.
Close the door as far as it will go.
4.
Hold the door on both sides and then close it again.
5.
Move it up and down and pull it out.
Positioning the door
1.
Follow the reverse order of disassembly of the door. When fitting the door, make sure that
both hinges fit correctly.
2.
When opening the door, lower the locking rod as shown in Figure 8.
If the door accidentally falls down or the hinges suddenly close, do not reach into the hinges.
Contact the official Cecotec Technical Support Service.
Disassembling and installing the door panel
Disassembling
1.
Remove the oven door as instructed and place it on a piece of cloth.
2.
Press the button on the inside door glass bracket with both hands. The bracket will be
released automatically. Fig. 9
3.
Remove the inner and centre panes.
Note
-
If the glass has some scratches, it may crack.
-
Do not use a glass spatula or abrasive cleaning agents for cleaning.
Installation
1.
Insert the inner pane into the slot.
2.
Both the right and left sides must be aligned with the slot. When they are, push the glass
into place.
3.
Position the oven door as shown.
Replacing the oven light bulb
If the oven light bulb fails, it must be replaced. Risk of electric shock!
1.
Switch off the circuit breaker in the fuse box.
2.
Place a kitchen towel in the oven when it is cold to prevent it from spoiling.
3.
Unscrew the glass cover by turning it counterclockwise.
4.
Replace the bulb with one of the same type.
BOLERO HEXA M236000
58
04725_04726_04727_04728_04729_04730_Horno Multifunción Bolero Hexa M236000.indd 58
04725_04726_04727_04728_04729_04730_Horno Multifunción Bolero Hexa M236000.indd 58
26/4/24 10:01
26/4/24 10:01
Publicité
