Publicité
GB
Please make sure there's enough space to install the treadmill and recommend 2 persons to install it.
WARNING: Don't insert the power wire until the treadmill was fully assembled.
Assembly tips:
1.In order to avoid instruction mistake, do not tighten bolt completely until the whole treadmill assembly is finished.
This treadmill packaged for 2 cartons. #1 carton is main frame.#2 carton is Handlebar and controller.
1. Opening the package and take the base frame out
Before the treadmill leave the factory, the frame and pallet
were fixed by holders and bolts. Using wrench to unscrew the
bolts (total 4pcs bolts) on frame, then take the base frame
out. (See figure 1)
2. Assembling left upright tube
A.
Install the Left upright tube (4) to base frame (1)
using four sets of bolt M10X25 (A4), Flat washersφ10
(C2) by side. (Attention: to align screw hole with the
upper surface). Make sure the bolts to connect left
upright tube and base frame. (See figure 2)
B.
In upper inner side, using one piece Flat
washer φ10 (C2) and one piece Nylon lock nut M10
(B4) to tighten. In upper outer side, using Bolt
M10X165 (A6) that was assembled on frame to
tighten.(Attention: bolt head position is the front
underside. See figure 2-1)
3.Assembling right upright tube
A. Connect the Signal wire from right upright tube
to corresponding wires from frame.
B. Install the Right upright tube (5) to base frame
(1) using four sets of bolt M10X25 (A4), Flat
washersφ10 (C2) by side. (Attention: to align
screw hole with the upper surface). Make sure
the bolts to connect left upright tube and base
frame. (See figure 3)
C. In upper inner side, using one piece Flat
washer φ10 (C2) and one piece Nylon lock nut
M10 (B4) to tighten. In upper outer side, using
Bolt M10X165 (A6) that was assembled on frame
to tighten.(Attention: bolt head position is the
front underside. See figure 3-1)
4. Assembling handlebar and controller
A. Connect the Signal wire from Right upright tube to corresponding
wires from Handlebar.
B. Install handlebar and controller set(6) to the Left/Right upright tube
(4,5).
C. Connect handlebar and controller(6) to the Left/Right upright tube
(4,5)
using
8
sets
washerφ10(C5),Flat washerφ10(C2). (Attention: To align screw
hole)(See figure 4)
of
Half-round
bolt
M10X20(A8),Spring
Publicité
